Reviews : Squadron Drill Bit #61-80 (20)
Sort
Reviews
Great to Have
The size range of the bits are very well worth the purchase. I had no idea how useful a pin vise was until I purchased one and then of course I needed a range of drill bits that did not come with it. This set fits the bill as the smallest of bits is almost or thinner than a hair. Work great for making holes, just don't use too much pressure while using them.
Squadron Drill Bit Index
This index is a must-have if you build ships. The sharpness and quality of the bits themselves are A-1, especially for drilling out holes in the hull, or deadeyes and blocks; plus they're handy for piercing sails. The only drawback is the dispenser.(It's kind of stiff, but that's minor.) I would definitely recommend it to any model-builder!
Great bits!
I bought these to replace my old Dremel set (I only used the smallest bit for plug wires) & am impressed. Wide assortment and works great with my pin vice. Just don't push too hard with the small ones. Also, when I opened the case everything fell out, so I put everything in an airbrush bottle except for the ones I always use. A must have!
Cheap useless bits, don't drill holes.
By: uncledick
These bits are absolute junk. Only a few actually drill a hole, the others just rub a dimple in plastic! Buy the more expensive set that actually works, the Excel EXL55510 set. I purchased one of those 30 or 40 years ago and they work! I didn't know they were available at Hobbylinc and bought these cheap ones instead.
Squadron Drill Bits
These drill bits are nice and sharp and really dig into the material you are putting a hole into. But the case it comes in could use directions on how to open it. I bent the smallest bit trying to slide open the case. That is why I give it 4 stars.
Great Set of Bits
Great needed set of drill bits for a great deal. I do lots of plastic work and with that comes some sculpting work. These drill bits do just great for all of that.
drill bits
very nice. very handy for making very small holes for model car carbs for vacuum hoses ect
DRILLS
By: hallingsebeau
THERE SMALL VERY SMALL BUT WORK WONDERFUL I WAS ABLE TO DRILL THREW BRASS WITH A 0.032 BIT