I was very lucky that this particular load was made. I model SP and there was a four track yard at Anderson, Ca., and there was a Simpson mill there. This was on SP's Valley Sub-division of the Sacramento Division. Scored big time and I'm waiting for the re-release the 72 foot center beam flat with opera windows. They've come up with a clever design. You pull them a part, and there are male / female pins. You set it on the car, you snap them back together through the windows and it's done. The graphics and lettering is excellent. Not seen in the picture is that there are little tips of 2x4's that separate the covered bundled loads they ride on. If you have a steady hand you could paint them. But there is one pretty big problem. The plastic protection went around each whole bundle. On this load the top doesn't have any printing or graphics (but there are section lines molded) but it's just white. Other than that it's a very good model.